Dragster using large wheels

                         This is a guide to help build using the instructions that came with the kit














































Glue the axle tabs to each each end of the wooden base.

The picture shows how the back wheels should look under the wooden base. Don’t forget - glue one wheel and pulley - pass the axle through both axle tabs- then glue the last wheel.

This is how the dragster will look after all the the wheels are in place.

Insert the motor into the bracket and peel off the base and stick where shown. Try and line the small pulley above the large pulley. Push over both pulleys the elastic bands - shorten if need.

Place the battery box towards the back and stick to base. Attach the two wires and switch on. If the Dragster goes backwards reverse the wires.